The spray drying tower is mainly used for spray drying of suspended liquid and high viscosity materials or solid content liquids. It can simultaneously perform the functions of drying and granulation. It is widely used in the spray drying towers of the food industry and chemical industry. The usual maintenance work must be done. In place, the life of the spray drying tower will be extended. So, what should you pay attention to during the maintenance of the Foshan spray drying tower?
1. Unnecessarily check and adjust the components of the spray drying tower. The parts and parts that need lubrication must be added with lubricating oil in time.
2. Keep the spray drying tower clean. If there is dirt, clean it in time.
3. When the dryer is used, it is necessary to observe whether the oil pump can supply oil normally after turning on the power supply. If abnormality occurs, it should be shut down immediately, and the oil pump should be repaired. It can be used after normal oil supply.
4. If the spray nozzle has noise and vibration during the operation, it is likely that there are residual impurities in the spray tray. At this time, it should be shut down immediately, and the impurities should be cleaned up before continuing to use.
5. When cleaning the system duct, ensure that every part is cleaned.
6. When cleaning the equipment, pay special attention to the dehumidifier, air sweeping device and air inlet fan to prevent water from entering in the equipment during cleaning.
7. When disassembling and assembling the atomizing disk, be careful not to bend the spindle. When reinstalling, the left-handed nut of the atomizing disk must be tightened to avoid loosening and affecting the use.